Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have a pix 501 with 10 license.i have 10 pc in my lan- all connecting to the internet at the same time.i also have a vpn site2site. does the communicathion in the site2site takes license from the 10 license i have for my lan pc?
i have pix 6.3.i have an outside and an inside int.my inside network has public ip's so it does nat 0.there is one pc in the inside that has access from the internet, the problem is that often the connection to this pc from outside is not accessible ...
i have a pix 501 ver 6.3 pdm 3.i want to apply a dns doctoring alias command so internal users will access my internal web site with his public dns name=public ipi did : alias (inside) 192.168.1.2 10.10.10.10 255.255.255.255 when 10.10.10.10 is the p...
I have a strabge situation- I have configured the pix (pdm3.0.1 ver 6.3.1) to permit dmz to outsite any ip .the dmz computers do have access to the outside but the strange thing is when i looked again on pdm at the rule i created- i saw that it chang...
all my attempts to configure split tunneling for a vpn user (pix 515) do not work. can some one please tell me why? I have configured the vpn user with the vpn wizard at the pix pdm , I have marked the checkbox for split tunnel. this is the config: (...
"access-list outside_access_in permit icmp any any ""nat (inside) 0 0.0.0.0 0.0.0.0 0 0"i have those configured and i can usualy ping the problematic statiion from the outside until i get requst time out and i see in log the error messege abovw..any ...
enable password means that when you will see the pix configuration, you will see the password you have set. with the enable secret command, the real password is encrypted so you will not see the real password when you see the configuration of the pi...
dont try to configure the set clock command because when you will reboot the router it will be lost. I think the best way is to configure : sntp server (ip address ) ver (?)and : clock timezone xxxfew ntp servers i know: 204.123.2.72 ver 3129.132.2....
the ports that I usually open for pc-anywhere are: 5631 tcp, 65301 tcp ,5632 udp, 22 udp (although some of them are for older versions of pcanywhere )I think that if you have opend all those ports with static nat and conduit it should work.
