Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I don't know much about ospf and I am having a problem. I have configured it in a redundant fashion with two routers at one site and two routers at another site. The problem is the routing table shows two entries for the same network to two differ...
Thanks I will give that a try but I think I maybe trying to do too much.Since both routers have a link to metro I was trying to guard against the cable being unplugged on the primary router to the metro in which case it should start routing to the se...
Hello GiuseppeThanks again for your insight I will analyze more in depth the cost for each route. I am however skeptical that I will be able to do anything about it since the E2 route metrics will always remain the same. I am confused as to why the t...
Hello All,I wish I could have responded sooner but I have been trying to get this up and running. I was told that I should test it in a lab before trying again so I have been using GNS3 but the deadline for me is fast approaching.Giuseppe the firewal...
Thank you everyone for your response. I am sorry I have not responded sooner but the email alerts went to spam so I did not know there were any responses.So let me see if I understand adding the cost to the interface based on how the cost is calculat...
