Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have several 7942G phones where the on/off hookswitch isn't working. You pick up the handset and nothing happens. If you select New Call or Answer the handset works just fine.
On 7941/61 phones I was able to take the phone apart and bend out the...
Have an issue with our FXS ports that are used for fax machines. If a call is active on the fax line and another call comes in to the same number, it locks up the phone system - phones can't do anything, buttons dont work for a minute or so and no c...
CUCM 10.5.2.11900-3, recently upgraded from 6.xxCalling to an outside number from a remote building, caller ID shows the wrong building on some phone carriers, but is correct on AT&T which provides our PRI lines.Example: Call to my AT&T cell, caller...
First off, our servers are old, EoL, EoS. New servers are planned but wont be here for quite awhile.Our voicemail server is dying. It will just shutdown at random times for no reason that we can find. Normally wouldn't be a problem as we can go wi...
None of those helped as the 7942G phone doesn't use that kind of spring or hookswitch contact. It uses an electric eye like this one:
http://www.refurbsupplies.com/storefrontCommerce/itemDetail.do?itm_id=2217
It acts like the eye just quit working f...
We have a contractor scheduled to look into the fax issue along with our caller ID issue next week. I think we'll survive for now.Thank you for your help. I learned quite a bit.
I was able to reconfigure the fax lines on the one gateway that uses MGCP. I now get a busy signal on the second call and no system lockup.Now the problem is, the other gateways are on h.323 and a second call to those pots lines locks the system. T...
Debug isdn log is attached.My call from 4592222 to 7243 starts at line 129 in Notepad++. It connects and I hear the fax tones. I then call from my desk phone, 8626646 to 7243. Starts at line 633. This call I get dead air.Same is true if I call from...
On fax dial-peers, fax rate disable command is not available for pots. Only see it on a dial-peer voice voip config.removed port on mgcp configOnly overlapping route patterns I see for 7243 are on the gateway itself. Dial-peer voice 111 voip and 11...
