Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking to upgrade to this switch and curious if anyone knows if it can hold the entire public BGP table. On the data sheet I'm showing it has 16GB of RAM but only holds 39000 routes. Does anyone have experience with entry counts above this?
Hello. I am looking for a suggestion on a Cisco routing device that meets the following criteria. The goal is to have it setup in a redundant configuration with the same model router. I appreciate any suggestions.
at least 10Gbps or 25Gbps of through...
I have several APs that I've inherited that are setup on lightweight software without a WLC that I can find. I've checked Cisco software and cannot find anywhere where I can download autonomous software for a 1242 AP to at least get these up and work...
Hello,
I've looked through data sheets and product specifications for the Meraki Z1 appliance. However, I'm unable to find any documentation that shows it's hardware specifications like processor, etc.
Where would be a good place to find this type o...
I'm able to pull up the uptime of switches/routers but I cannot find a report to do that in a batch. Is there any way of doing this is Prime Infrastructure 2.1?
Leo,
Looks like it is but confirming that BGP is supported on the Catalyst 8500 switch / IOS XE software (https://www.cisco.com/c/en/us/td/docs/routers/ios/config/17-x/ip-routing/b-ip-routing/m_irg-bgp-pol-acct.html). Haven't had to chance to impleme...
