Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have recently got a couple of 2811 16-TS routers running 12.4(15)T9. I am not able to configure it properly to access the console of different devices using terminal server. I have gone through some of the docs but some commands are not support...
Hi, I have configured RA VPN in ASA 5520 running 8.0(2). The vpn gets connected from both a PAT & a NAT source but host access over this VPN only works for connections from NAT source and not any PAT source.Hope I am able to clarify the issue.Pls he...
Hi, I have 2 ASA 5520 working in a statefull Active/Failover mode connected to two different routers which are working in HSRP. Now the routers are always taking a Active Active state as the HSRP heartbeats and communications are getting blocked by ...
hi, I have been noticing this issue of the ASA not able to assign ip address to the RA VPN clients from its local pool. The same config used to work without any issues but suddenly it has stopped working. Earlier also I faced the same issue but got i...
Hi, I have configured a RA VPN in a pair of Cisco ASA 5520 with LDAp authentication and local ip address pool. The RA VPN is working fine when I connect it from a direct internet with a public ip assigned to the client desktop without any firewall o...
ok thanks but i resolved this issue. in my case the failover was configured to be replicated over the http protocol which was not able to properly sync the pair for this ip address pool, once i made the replication to run on default the problem got r...
it must be the ACL, how you are restricting access from DMZ to inside. there must be a acl for the dmz interface to restrict traffic if i am not wrong allow traffic there towards internet and you will be all set to go.
