Hi, first of all, this is possible right? We are in L3 mode of course.1. How does discovery work? i.e. How does the VSM find the hosts over L3? I don't see any commands that target an IP address...2. What ports need to be opened? Thanks, Claire
When you use the spanning-tree mst simulate pvst disable command, specified MST interfaces that receive a Rapid PVST+ (SSTP) bridge protocol data unit (BPDU) move into the STP blocking state. Those interfaces remain in the inconsistent state until th...
Agreed, I'm also of the opinion that you need a class and a policy for loadbalancing and a class and policy for nat. Both policies receive the incoming traffic, then perform their seperate operations on it and meet up afterwards.In it's simplest form...
I'm pretty sure it's provided with the ACE. I certainly didn't have to install it. It does get listed when you purchase equipment, but I don't think they actually provide a seperate license file with delivery. Have you received the eqt? Did they prov...
Just had another thought, if there is no L3 interface for your server side vlan on the switch, it won't hold an ip arp table for that vlan. My solution for this problem (contacting a server behind an ACE using connectionless protocols, icmp, snmp etc...
Hiya,Does the arp entry exist for the vlan interface on the ACE?I assume you have permitted the vlan in your svclc commands on the switch as you can ping from ACE to server. The above is correct, it behaves like a firewall and nothing is permitted by...
