Greetings -- I've just picked up an 881 and 2 521's. I have the 881 setup fine with the CP Express. No problem there. Now I'd like to get these 2 APs running but I haven't been able to figure out the first thing. I've attempted using the CCA to d...
I have two 521's and both behave the same way. I only have a 881 and have the 521 plugged into the switch builtin to the 881. Since the 881 is not supported on the CCA, I cannot configure a port as an AP smart port. Can I do this from the command l...
I've consoled into a 521 and from there can determine the IP. A port scan of the 521 reveals no open ports and CCA needs 80/443 I believe. The config command is unrecognized on the console. I have the latest version of CCA but without any open por...
Thanks Bill -- Thanks for the reply. I saw that last week. No help. I actually did get into the console yesterday and discovered that it was getting an IP. However, there are no ports open and CCA needs HTTP[S] I believe. It wont allow me to co...