Hello Experts,There are two FPR1120 firewalls working as Active/Standby, and two stacked C9300L switches.Please let me know if the PortFast and BPDU filter can be enabled for the firewall interface ports on C9300L switches.I'm wondering if the enable...
Hi,I'm checking the communication between the nodes connected to subinterfaces and physical ports. I can ping from the nodes connected to subinterfaces to the firewall but not from the nodes on the physical ports to the firewall. Please check my conf...
Hi,I will have a FPR1120 ASA firewall with routed mode, and two network switches will be connected to the firewall with the same subnet. Please let me know if multiple ports with the same subnet can be configured in FPR1120 with routed mode.Thank you...
Please let me know how to configure a firewall port where a network switch port that has a VLAN configuration (trunk mode) is connected.Thank you in advance!Regards,Sangyeon
Hi,I'll have two Firepower FPR1120-ASA-K9 that will be configured as High Availability (Active and Standby).Please let me know if they should have the same management IP address and bridged network address.Thank you in advance!Regards,Sangyeon
Hi Marius,No, I'm still waiting for the comments or insights from the experts. I believe the port configuration on the network switch is correct.If you have any other comments or insights, please let me know.Regards,SY
Hi BB,Thank you for your reply! Actually, there are four network switches. Two switches are in the inside network, and two switches are in the outside network. Two switches in the outside network have vlan 10, 20, and 30. One of two switches in the i...
Hi MHM,Thank you for your reply! Actually, there are four network switches. Two switches are in the inside network, and two switches are in the outside network. Two switches in the outside network have vlan 10, 20, and 30. One of two switches in the ...
