Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts, i have a question about enforce Subnet checkdo you know if you enable it in a fabric pure of gen2 devices, are going to be some troubles about it? * missing endpoints? in only the BD where the fault F3083 appears *flush of all endpoint...
Hi experts, is there any document to feel like confident abouthaving a production cluster with L2 and M3 cluster going on, this of migration from new hardware? there is some recommendation about it?best regards
Hi experts in the installation guideit doesnt shows how much devices is supported in trial license, because the client buy 3 flowsensor and 1 flow collectorbut adding the last flowsensor it shows this error, its in the attached files, this error hap...
Hi experts,i have a doubt about usegif you have only one interface connected to a vcenter-esxi host and its a VDS to a leaf deviceand you want to enable useg with a physical dom, because there is no a vm integration only with ip address or mac becaus...
Hi experts, we have a fabric 4.2and i want to upgrade it to 5.xbut we have some spines 9336PQ i believe this one are 1 genso in this link, shows that the cisco ACI version 5.x are not going to support 1 gen switchthis info its confirm and the clients...
Hi Sergiu, hope you are doing finethanks for the response i ll test it in a lab environment to see all the phases that the clients need itthanks for your reply
Hi RedNectar, hope you are doing well, thanks a lot for the answer so if that is going to happen for the filter, so maybe other behavior could happen after the upgrademaybe those 1gen devices could take the change to version 5, but considering this u...
Hi Wes, thanks a lot, that was the problem, i could not log in to the new CIMC and i was getting worried about it, now i have access, thanks a lot for your time, best regards
thanks a lot for the guide to make the upgrade, very appreciated can i ask a last question, when someone make ISSUit shows that sup standby is upgraded and then comes the switch to the primarybut what happens to the line cards of the chassis?this lin...
thanks about the replybut when you configure the ad integration it's simple and pretty straightforward, but i mean aboutwith the AD because i have some troubles about with the ad integration some users shows data like email and those AD stuff and ano...
