I have two issues with my SG300-52 switches. I have configured the same VLANs on both of them for availability and redundancy. The switches connect to a router, and clients get IP addresses from a 2k8 DHCP server. My issues are: 1. I get 2 or three ...

I have an sg300-52 switch on which I can access all the vlans but am unable to access the internet. I have attached my configurations below. The default gateway is an interface on my router. I now think that my configurations are not right. May you p...

I have an SG300-52 which I upgraded firmware to 1.4.1.3 and the boot code to 1.3.5.6. Now I have created several VLANs and set the ports as Untagged Access ports. When I try to assign an IP address to the VLANs (not the Management VLAN), the GUI beco...