Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Will the MX appliance advertise the remote VPN learned subnets via OSPF out of the LAN interface(s)? Seems, I have seen some code enhancements to allow this but unsure of the requirements/restrictions.
I haven't been able to find a definitive answer to whether or not the interfaces that come on the Firepower SSP module for a 5585-X are dedicated to Firepower or can be shared/used ASA Firewall component, i.e. would like to have my "inside" interface...
What is the required MDS code level needed to support FC Port-Channeling/Trunking on a 9222i, 9148, or 9509/9513 w/ Gen2 line cards to UCS 1.4(3)?I know the fport-channel-trunk feature is needed and was released in MDS 4.2 code but I have seen docume...
I know how to set a remotely authenticated/authorized users Role using the Radius av-pairs with UCS. What Radius attribute/av-pair syntax is needed to set the users Locale within UCS? I have tried shell:roles="role@locales" and shell:locales="locale ...
Yep, great feedback, GreenMan.The upstream/L3 switch that you mention will be the decision maker in this scenario. In the future, they are considering a separate MPLS WAN (via Cisco ISR connected to distro Meraki425) that will also inject dynamic le...
Thank you for your response GreenMan. I have seen the Deployment Guide in the past, but thank you for bringing it to my attention again.The customer (relatively small) has 6 remote sites, they will initially be using the MXs as both an Internet edge...
Thank you PhilipDAth The key to me is that it will form an OSPF neighbor relationship and advertise via the LAN interfaces (not the WAN) interfaces.Is that indeed the case? Also, I have read a couple of Meraki guides that indicate the VLANs must be...
Thanks Adam. Maybe I should clarify my question. I am not concerned with Inbound (internet into MX) translation here. This is typically accomplished with 1:1 static NATs or some form of Port Forwarding (static PAT). My question is will the MX per...
Michael,Yes, I have read through the document you reference. The author mentions MDS 5.0(4) or higher code level specifically. I was just writing for confirmation. I have been unsuccessful in finding any mention of requiring 5.0(4), outside of this...
