Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a strange problem with Cisco ACS 4.2 appliance.The problem is that i had configured the ACS appliance with a remote agent to Integrate with Microsoft active directory and I installed that agent on one of our domain controls and it is working...
I have the following scenario to connect my main HQ with other branches:Two routers at the HQ and work in HSRP by thier internal Giga interface and use WAN connections by serial interfaces to create site to site VPN with other branches by using GRE o...
I am trying to create site to site vpn between Cisco ASA 5510 and Linux OpenSwan, after completed the configuration from both side the VPN tunnel came but nothing is passing through the tunnel.I am using software version 8.0(4) on my ASA firewall, s...
i need to clear some point:i am using the lan interface to create failover between the two router in case on the fail of the active HSRP , the standby will take the tunnels with the branches router.i didn't know about that i didn't need to apply the ...
Thanks for your reply, and sorry but there was some missing part at the configuration that i postedi am currently applying the crypto map to the gre tunnel, serial interface and HSRP interface G0/0for the the WAN connection both HQ routers have wan c...
thanks a lot for you support, but i was asking if the NAT and route are correct at the Linux firewall and still i can't make any traffic pass through the tunnel can one of the following bugs cased that problem(CSCtd36473, CSCtb53186)my current ASA so...
