Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Are the serial commands for power on/off for the Cisco 32" LCDs different than the 40" and 52" monitors?The "rs232.tx_hex=aa11fe010111" for power on and "rs232.tx_hex=aa11fe010010" work fine on the 40"s but the 32"s do not respond to these same comma...
I am trying to migrate from an a DMM 5.0 box that is running on old supported hardware platform to a new DMM 5.2.1 box on supported hardware.Is it possible to upgrade the DMPs ONLY and point them to a new DMM without upgrading the DMM?I am having an ...
I need to find out if there is a way to determine the manufacture date of Cisco equipment like 1602, 1604 & PIX506? The 1600 routers do not have a physical date printed any where on the case.This is for a customer.
Tomas,Thanks, but I am not seeing the information for my question. I can downgrade the DMPs from 5.2.1 back to 5.0.2. The question then becomes 'HOW' do I upgrade the kernel before upgrading the firmware to 5.2.1. There is no way to do this in 5.0.2 ...
I wanted to add: this is slightly different than anything listed in the install guide(s) since I am not (can't physically since it is unsupported hardware) upgrading the current DMM. I have tried to follow the guide(s) as closely as possible. The onl...
