Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiReally new at ACS I was wondering if this is possible.For a school division using AD, school division would like to use radius 4.2 ACS for the AD users to access the network wired or wirelss.For rogue users they want them to go to guest default vl...
I have to separate Cm's joined together with a ic trunk, On first Cm I have a intergrated unity with a few subs, I have mwi working for subs on intergrated Cm, On the Cm across wan I have one test sub I have vmail functioning the same as intergrated ...
I have a client that says the srst gateways are dropping pstn calls after 5 mins, client recently did upgrade to 7.0 CM suspect the routers may have needed up grade as well? not sure of all issues yet I will be doing a q&a on Wed with client. Just as...
Have a CME with 7921 ,7970 paging works fine to 70 from a 70 or 21 but 21 to 21 drops constantly.The CME 4.3 and the 7921 has latest f/w.Also wlc has f/w 4.2.130.has anyone ran into this issue.Phones and CME are on same subnet and same sw stack. WLC ...
I have 6.1 CM it seems that the when an ext dials pstn calls they take up to 20 secs to complete. this has been same even when pressing#. I have debugged gateway and found that the digits are taking 15 secs to get there then matched by dialpeer and r...
NoI even put in a tac case with no luck from them eitherThis was awhile ago there's been a few changes to CUCM and Unity since.Might work now?Brad Marlin CSA Senior Design Security/WirelessSaskTel 1825 Lorne StRegina SK S4P 3Y2Phone 777-5274Cell 533...
Good Morning FarrukhThanks for the reply,I guess I should have indicated that all AD users, wired and wireless go to authenticate to AD radius and rogue wired and wireless authenticate to internal ACS db then go to guest vlan. Is this possible for t...
Hi Rob, I setup a dn on a set across same css as mwi dn is 1277 mwi 1298 I call set that is across wan from this line, I think it might be a unity issue. like a restriction table of some sort maybe?Thanks for the feedback
Hi, yes I thought of that also but it doesn't make any difference.I put a dn that is similar to mwi IE mwi 1299 dn 1200 on a phone across wan I can call that phone.
