About jdpethybridg

jdpethybridg · 10-21-2009

The c2960 doc's do not show what the GREEN and RED alarm temperatures are ( unlike a c3750). The C2960 does not have a temperature Value only a Status.You can set the YELLOW alarm to X DegC below the RED alarm, but i can not find out how to tell what...

jdpethybridg · 11-08-2009

I have just had a Call from Cisco. They are not 100% sure that the non Gig 2960 even has a temperature sender in side. This may allow a 2960 to state that its "OK" when its not. I suggested the switch should reply with something that indicates that a...

jdpethybridg · 10-28-2009

After More testing.Only 2960G devices look to give a status.These switches have different Motherboard Ass# and Top Assembly#.All tested 2960 and 2960G units have the same the same firmware ( LanBaseK9 ).Shockingly on the 2960G the yellow defaults to ...

jdpethybridg · 10-24-2009

More testing done.I left the YELLOW alarm at its Default.I put the 2960-8TC in an incubator with circulation fans and two thermometers, one on the case of the 2960 , the other in the 2960 resting on the PCB ( via a side vent hole)I ramped the tempera...

jdpethybridg · 10-22-2009

Thanx jbrenesi. but the RED is not 45. I don't want to put a 2960 in the pie warmer but have one in 45 to 48 DegC and its not alarmed. the RED for a 3750 is 61. thats all i would assume ( but then again the non fan 2960s have an environmental opperat...

Member Since	‎10-21-2009 01:55 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	5
Total Helpful Votes Received	15

User Statistics

User Activity

C2960 Temerature alarm thresholds ?

Re: C2960 Temerature alarm thresholds ?

Re: C2960 Temerature alarm thresholds ?

Re: C2960 Temerature alarm thresholds ?

Re: C2960 Temerature alarm thresholds ?