Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi There,We are planning to use two Aironet's 1252 over an 2.7 km point to point link.One of the options we have it to install three HyperLink Parabolig Grid 5.8 MHz 27 dBi antennas in parallel for every 1252.I have some concerns because those antenn...
Hi All,I'm trying to set up a site-to-site VPN using two Cisco ASA 5510, version 8, ADSM 6.I have used the IPSec VPN wizard, picked the site to site option, passed trough the process, the configuration went delivered on both devices without errors.Ho...
Hi All,The previous problem of which I started another conversation here:http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=General&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddba023 somehow diss...
Hi All,We have recently installed an wireless WAN link over 7 km (aproximate 4.5 milles) distance. The towers are sufficent for fresnel and earth bulge and obstacles requirements.We have used Cisco Aironet 1310 bridges (one configured as root bridge,...
Hi All,I have been checking the "Cisco Systems Aironet 1310 Intallation" manuals, and have noticed that the external antenna model has connectors for two antennas.My question is if this device could be used as repetitor (logically splitting the signa...
Hi Steve,I have seen the Q&A section for the Aironet 1250:http://www.cisco.com/en/US/prod/collateral/wireless/ps5678/ps6973/ps8382/prod_qas0900aecd806b7c82_ps6973_Products_Q_and_A_Item.htmlstates that both root and non-root bridge modes are supported...
Hi All,Thank you for the information. I configured the distance on the root bridges, but the links showed instability.I'm using a bi-directional amplifier. It has two pieces. According to the manuals, one is installed indoors, the other outdoors. I'm...
Hi,Thank you for the information. The distance from the central node is less than 0.8 milles.I have disabled the OFDM speeds at the central node and it's working at 11 Mbps, so far very stable, with almost no lost packets.It seems that the problem wa...
Hi,I spoke yesterday with the local Cisco Systems office. They have told me that a multipoint link using Aironet 1310's should operate in the 48-24 Mbps range within the 1 km range.I'm attaching a Cisco Excel (freeware) utility which helps to figure ...
Hi,When there are VLAN's the pings are quite missleading.Besides latency, one should measure the quality of the links (lost packets), their capacity (Mbps), and confiability (uptime).Finally, the security is another important factor.Best Regards,Igor...
