Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 4400 series controller capable of 25 access points. I currently have 11 deployed and the controller is only seeing 10. Also if I have the need to reset a switch the AP is hanging from it can take days for the AP to find itself again, if it f...
How often does Cisco recommend I update my network equipment's firmware rev. We have Catalyst 6500,3500 and 3700 series switches and 2600 series routers.
I double checked and it is set to Auto/Auto. It is connected to a Cisco Catalyst 6513 on a WS-X6454-ge-tx board. It's port is setup as a trunk but I am having difficulities setting it to a dot1q trunk. I was trying to use the "switchport trunk encaps...
Hi, Thanks for your reply. We have one controller. The controller and AP are on the same VLAN. We are using a static address for the controller. The controller is connected to a Catalyst 6513 on a 24 port Gig E blade. The port is set to 1 gig. I ha...
Aaron,Thanks for your reply. I have already tried the VLAN checks since I figured maybe I missed something. I am confused because they will work for a while but say we lose power and the switch dies, Once it comes up the AP takes a long time (Days so...
