Hi folksI do need some clarification on frame-relay configuration Inverse ARP. I do have tow books but but I'm getting different information as far as configuring a frame-relay between two routers.Here is the information from 1st book:Single Inter...
Hi folks,I have configured vlan 2 and vlan 3 on my switch and trunk them to my router and I do have connectivity between those two vlans..When configured the router sub-interface f0/0.1,f0/0.2 and f0/0.3 I have used the fallowing ip address 10.37...
Hi every one, The console port is stuck at 115200 even after changing it in ROMMON mode to 9600 by set BAUD 9600 and unset command neither one seems to help.
Hi folks ,I desperately need help from you all here,I tried to upgrade my switch 2900xl series ,but I upload the tar format of the ios without using the appropriate command and it didn't obviously work then I deleted it and now I want to load bac...
You may be right but every documentation I have red they don't assign ip address to a main interface,the just put no shutdown.That is why I have said that
This is exactely I have configured and that is why I do have connectivity between vlan 2 and 3.You can see these output from the router and switch:R1#sh vlanVirtual LAN ID: 1 (IEEE 802.1Q Encapsulation) vLAN Trunk Interface: Ethernet0/0.1 This i...