Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
C9130AXI-B Access Point configured as WLCI am trying to change the Tx power level via GUI and I get the following messageError in Configuring Access Point: Error no ap_name existsin GUI the AP name looks like this:From the command prompt (show ap con...
Hello All,I cannot get C9130AXI-B Access Point to get IP addresses from DHCP Server.ConfigurationDHCP Server (dhcpserver.de) is on Win 11, connected to Cisco Catalyst C1200-8FP-2G PoE switchC9130AXI-B running EWC image v17.12.03 connected to the same...
I got a couple of C9130AXI-B Access Points to build a small Wi-Fi network (2-3 Cisco APs). I thought it has the Embedded Wireless Controller as stated in the Data sheet for the 9130AX series or did I get the wrong part number and I should have bought...
No, I don't have a backup.Both are running the capwap image and they are looking for the controller on the network during the bootup. Without finding it, they boot the AP image. It sounds like getting the image from the tftp server is the only option...
Thanks.This commands requires the tftp server file location.ap-type ewc-ap
WORD URL of AP image <tftp|sftp>://<server_ip>/<file_path>Will I need to specify both the AP image and EWC image like in the example below?ap-type ewc-ap tftp://192.168.1....
I was able to change the name from the AP mode using capwap ap hostname <APXXXX.XXXX.XXXX> but now the AP does not boot into the EWC mode (boots in AP mode). How do I reconfigure it to boot into the EWC mode again?
The hostname seems to be correct in the Wizard: WLCXXXX.XXXX.XXXX (X- Mac Address), but the AP address is not.Are you saying that I should change the hostname from WLCXXXX.XXXX.XXXX to APXXXX.XXXX.XXXX?
