Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I did it using the CCNA Study Guide by Todd Lammle.Be sure it says "Fith Edition" and "Exam 640-801" on the cover before you buy it. I picked up a 2501 router from Ebay to practice the "Hands-on Labs".See http://www.richpri.org/info/content/category...
This is just a guess but . . .Try adding a switchport command to each interface.For example:interface GigabitEthernet4/0/1 switchport mode trunk channel-group 1 mode on
OK I get it now!The "Break" key is the one labeled "Pause Break" [It's in the upper right corner of the keyboard on my laptop and it's next to the "scroll lock" key on my desktop keyboard.] Holding down "Ctrl" and pressing this key works like a charm...
I have a 2501 that I am using for CCNA practice. After reading this thread I decided to try to interrupt the boot sequence on my router as a learning experience.I too am unable to do so!Perhaps I am mistaken about what the "break key" is when using ...
