Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,What are the clocking options for a POS Line card or Port on a Cisco 12008 GSR.1) Internal2) Line3) Sysclock???4) BITS ???How can I configure the sysclock?? IOS Commands??ThanksNitin
Shan,What platform are you using? If you are using same Fiber pair for the TX,RX then Loss Budget is same @ both ends, How will 1550 @ one end and 1310 @ other end will help you? 1310 reception @ 1550 end will be poor enough to give you headache's al...
Hey Brad,This is what Cisco has to say about FlexWan"The FlexWAN module for the Cisco® 7600 Series Router and Cisco Catalyst® 6500 Series Switch enables high-performance, intelligent LAN, WAN, and metropolitan-area network (MAN) service scalability f...
Hey Shan,Can you pl. elaborate a little bit more?. Do you want to use 1310 and 1550 on two ends of the Point to point POS?Mixing 1310 and 1550 is not a good idea, to start with.
MK,This is not a simple Span upgrade, Nell is upgrading a subtended OC-12 UPSR to a subtended OC-48 UPSR. Span would normally involve single OC-12/48 card (in case of 2F-UPSR) where as a subtended OC-12/48 UPSR will involve 2 OC-12/48 cards.Cross con...
