Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Description: Recently, I came across information indicating that on Nexus3000 series switches, the default route takes precedence over the next hop set by the "ip default next-hop" operator. This observation was made through the following Bug ID: CSC...
Problem Description:I am encountering an issue with the "set ip default next-hop" command on my n3k-c3064pq-10ge device.Device Information:Model: n3k-c3064pq-10geSoftware:BIOS: version 5.0.0NXOS: version 9.3(13)Configuration Attempt:I am attempting t...
The command set default ip next-hop appears to be non-functional. Even after removing the default route from the main routing table, packets remain trapped within the route-map rules without progressing further. Only 'set ip next-hop' seems to work, ...
I understand you. But what I need is not reservation, but static distribution based on incoming networks. For example, this network on gateway 10.10.10.1, another network, let it come from another interface, should go to another gateway, let it be 20...
Hello. Please provide an example, as I don't fully understand the concept from your words. Thank you!p.s.no ip route 0.0.0.0/0 10.10.3.1
route-map PBR-VLAN82 permit 10
match ip address VLAN82-ACL
set default ip next-hop 10.10.3.1
route-map PBR...
I need 'set ip default next hop', currently using Catalyst 6509, would like to change the equipment while retaining the ability to perform 'set ip default next hop'. What can you recommend as a replacement for the 6509? Tnx!
