Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently migrated to a new ISP and utilized a new port for setup on our Cisco FP 1150. Everything seems to have gone off without a hitch, the site is online and utilizing the new ISP, however, the ISP/WAN/Gateway is still trying to use the old por...
Hi,I have a Cisco FTD 1150, looking to install a new ISP fiber connection. Currently, I have port 1/9 enabled, however, when I plug in the second SFP module to any of the other SFP ports (1/10-1/12), the 1/9 port gets disconnected along with the new ...
I have recently taken over a site that utilizes a Cisco Router to act as their public facing device/firewall. I have been tasked with setting up a IKEv2 S2S tunnel with one of our external vendors, and it will need to be setup on this router.I have w...
We changed the ISP, but the Management Interface config was and still is set up with the old ISP and its Public IP address. As of now, we have not migrated over the Management Interface to the new ISP.We are utilizing the Cisco DNS Servers and have t...
Could this be due to the Management Gateway Interface Settings? On the old ISP, we had two ports active on the modem, so we had both the Outside Interface, and the MGMT Interface, with different IP addresses plugging directly into the ISPs modem.Now,...
We inherited this site/device, and it appears it does not have active support contract. Still working with Cisco to get the device ownership migrated before we can set up a new support contract.So, in general, these should be plug and play, nothing s...
They are not Cisco branded SFP modules, but verified to be compatible through the supported SFP list found below.https://www.cisco.com/c/en/us/td/docs/security/firepower/1100/hw/guide/hw-install-1100/overview.html
Quick update, I was able to get the tunnel applied without brining down the site with the above information. Really appreciate all the help. However, the tunnel is showing DOWN, and I was just informed I will need to implement a NAT on our side of th...
