Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i've recently tried to enable IPv6 but since then, the router has gone wild.A few minutes after reboot it starts to send "malformed IPv6" packages (according to wireshark), stops responding to DHCPv6 solicitations, forwards packets just to a very ...
Hi,
i've been messing around with the configuration since hours, but failed
to get a stable IPv6 connection into the internet. While doing that,
i've also discovered several shortcomings.
First things first, the configuration of the router:
WAN -> ...
i've recently tried to download suse 11.3 via bittorrent.first the speed in µTorrent 2.0.2 went straight to the bandwith maximum, but after a view minutes it went lower and lower till it reached about 2-3 kbps.curious about this, i've checked the Pee...
Hi Guys I've done a portscan and discovered that there are at least three ports open, where i don't think that they shouldn't.8118 -> Privoxy, but delivers the WRVS admin page. So the web-content filtering on the WRVS is done by privoxy, but someone...
the problem is hidden in the routing table of the router.since the (ipv6) settings aren't accessable through the WebUI, i had to downgrade to a older firmware, get a utelnetd from a rvs opensource firmware package and copy it onto the router. that do...
sorry for "kidnapping" the thread, but i've some problems which are definitly router (or better router OS) based.it's easy to ignore IPv6 related problems right now, but there will be more and more WRVS4400n and RVS4000 users who will try the IPv6 fe...
you could try to telnet to the router (or the bootloader "boot world") which is used at the rvs4000 and wrvs4400n (v2). there is a recovery tool for the rvs4000, but since the partition tables of the two routers differ, i don't know if its a good ide...
i've tried to get it working, but got no answer in this forum. it seems that they try to frustrate you enough to get another device and hope that it will be another cisco ...https://supportforums.cisco.com/thread/2125770https://supportforums.cisco.co...
are you trying to start the upgrade via a vpn or via the wan remote management port?i think it's just enabled if you are in the "LAN" section of the router.regardsDominik
