Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, I have a 5525x running in the network and have a 5510 in stock. Can we copy the configuration from 5525 to 5510 ? what is the better way of doing this? I dont have a smartnet for 5525 x , so it will be better if I keep the 5510 ready incase...
Dear All, I have a 5525 X with firepower running in the network. I am thinking of adding a failover device as I have a 5510 ASA in stock. Can I do this configuration? What are the requirements ? Thanks
Dears, I am trying to publish a internal portal for external access. The portal runs on port 80 internally and wanted to confugure this on port 8080 for external access. All port forwarding is configured on firewall and router. But for some reason po...
Dears, I am planning to upgrade our 2960 switches (10+ years old) in the network. Can you please recommend which model I should go for? I am looking to get 24 and 48 ports as appropriate. When searched I could see a whole different series of 2960. I ...
Dears, I have a cisco Asa 5510 which is doing some basic firewall roles in the network. And 1941 router which is our internet router. We are planning to provide VPN access and also host an database which needs to be accessed from the internet. It w...
Thankjs, I have IPS enabled in 5525x which I know cannot be migrated to 5510. What I would like is to make the 5510 as a basic firewall when 5525 goes down so that the network is not effected.
http://77.234.44.24/ that is not my ip address. I googled it and found its avast's IP.
Mine should be a IIS start page upon typing the IP.
ip nat inside source static tcp 10.40.50.50 8080 interface Dialer0 8080
also not working. I has to be the I...
I have a intranet page on DMZ which is 10.40.50.50:80 . I wanted people to access this from outside the network so that when they type x.x.x.x:8080 it should reach 10.40.50.50:80.
When I configure x.x.x.x:443 to 10.40.50.50:80 it works.
But when I c...
