Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two controllers, one AIR-CT5508-K9 and another Cisco Catalyst 9800-CL, what is happening is the following:The old access points model AIR-AP1832I-Z-K9 only associate with the new 9800 controller, in the old one it associates but does not recei...
Good afternoon and sorry for the delay, I did several tests and it didn't work, as the equipment is no longer under warranty I couldn't open Tac on Cisco, I left it working on the new controller.Thank you very much for the support.
Good morning, the AP is getting IP via DHCP but it does not associate with the controller, only with the new one, I left the AP running on the 9800 controller.
10.7.8.52 is the new controller, I set the IP to 10.7.254.245 and it works normally, I'm going to reset the AP and do new tests with it trying to get the DHCP IP.
Good afternoon, switching and routing everything okWhen I put a computer on the door it gets the IP via DHCP but I like to leave it with a fixed IP P1416.9D50.4F48:capwap ap primary-base WLC_CC4 10.7.8.52AP1416.9D50.4F48#show capwap ip configIP Addre...
Thank you in advance for your attention, the ap came with the factory configuration, the switch is on default vlan 1Even forcing the ap on the old controller, it does not associate only with the new one.
