Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,I am currently in the process of auditing network ports in a certain vlan to see if they need to stay in use or not. Is there any way (show command)that I can reliably tell if the port is in use still? I check the counters and the status of ...
Hi,I have a new Catalyst 2960G 8TC that I accidentally blew the image away on. I am trying to Xmodem it over, but it doesn't work... The first 4 000 000 or so bytes go through just fine, then it seems that the switch starts interpreting the informati...
Hi Guys,I have two Cisco Catalyst 2960G switches that I am trying to trunk together.Each switch has a SFP transciever module plugged into the gi0/24 GBIC port. My setup is like this:switch1----media converter******media converter-----switch2- is LC t...
Hi,I am configuring a couple Cisco 2960G switches and for some reason, the VTP information (mode client/domain) doesn't stay in the configuration upon reload (after a copy run start of course). The switches aren't connected together, or to any other ...
Version 12.1(19)EW1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1) ROM: 12.2(20r)EW1I've been googling for command references for that release and I never find anything reliable...
Looks like this has opened up a new question for me... I can't find documentation on this command and the difference in output anywhere!Anyone know why there's a difference between my output from show interfaces link command:Port Name ...
