Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have you received error messages in your Cisco routers that are not documented anywhere? Welcome to the Cisco-ErrorMessage-Decryption club.ISDN Se0/0/0:23 SERROR: Pri_Activate_L2: BAD states = 0, 6; IDBS_UP 4and sometimes BAD states 0,0. Any ideas a...
I have a vwic-MFT-1T1 connected to a PRI from Verizon. T1 is down, Verizon has tested and they believe line is working fine. I can see a lot of LCV and PCV. No alarms.What exacly a loopback diag do? is it a local loop or remote?I have a diag loopback...
I have 7961G-GE registered to CME4.0, with 7.0.3.0S Firmware loaded on the phone.The main problem right now is, when I dial an outside number, I hear static noise while rining-and only during ringing.Also, the phone is looking for g3-tones.xml and mk...
I think you're right and the brand new VWIC is the problem. Just to make sure, can you tell me if this config is correct?I have a 2811 with 12.4.4XC1 and PVDMs for only 16 channels...network-clock-participate wic 0!isdn switch-type primary-ni!voice-c...
Some more debug info:#loopback diagApr 20 23:36:41.370: %CONTROLLER-5-UPDOWN: Controller T1 0/0/0, changed state to upApr 20 23:36:41.370: ISDN Se0/0/0:23 SERROR: service_queue_from_physical_layer:got ISDN_PH_ACT_IND on an active interface?Apr 20 23:...
I have reloaded the server many times. It didnt fix it. So loopback diag means it loops the PRI link towards the router? bits never leave the VWIC port if it's in loopback diag?If i physically disconnect the link from the port, I'll get the same resu...
The memory requirements are estimates. Sometimes when Cisco says you need 128MB, it works with 64MB DRAM too, but with minimum configuration. The only way to check is loading IOS and checking console when booting up...
I think this should be posted as a bug or an upgrade request to Cisco, or they should mention it somewhere for CME too.If anybody here can send me mk-sccp.jar for United States too, that will help me get rid of error message here too!For mixed Englis...
