HelloIs it possible to route calls by calling number in CCM? For example. Inbounds calls with calling prefix 0034 route to extension 101 and calls with the rest of prefix route to extension 102 ?I read some threads to do the same but talk about scrip...
HelloWe have a trunk SIP between CCM 4.1(3) and Asterisk 1.2 working fine with codecs g711u/g711a.We want to change the trunk's codec to g729 for WAN link.Incoming calls (from asterisk to ccm) work fine (profile mtp (cisco 2801) or profile xcode) wit...
HiI bit question ....Can CCM do transcoding with software resources (CPU of CCM) or its necessary a hardware resources like PVDM2?By default CCM create resource for ANN, CFB,MOH and MTP, but not for XCODE .... Thanks very much
Hola AlejandroSorry for my last question, I confused h323 gateway (voice router) with the h323 gateway device in CCM.I read your answer in CVOICE. The calling number ANI with answer-address is useful when you want to match calls based onthe originati...
Thanks Juan LuisI think translation pattern work before CCM route decision and based on called number. The result of the translation (the translated called number) go to the CCM router decision and finally CCM route the call.How can I do routing by c...
HiThere is a nice document in voip-info.org.Take a look http://www.voip-info.org/wiki/view/Asterisk+Cisco+CallManager+IntegrationIf you has any doubt contact me again.Cheers
HiThanks for your answerIncomings calls from asterisk to ccm 4.x work in g729 with mtp resource or xcode in 2801, depending of the regions and device pool configuration.How is it possible if ccm 4.x only work with g711 over trunk sip ?Thanks a lot