Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We are considering WAAS as an optimization solution. However we have many homegrown applications.
From what I have read so far, it seems like WAAS needs some configuration to correctly handle some applications.
What will be necessary for us to co...
Hi!I am searching for good Polciy Based Routing Configuration examples for the 6509 and 4948.I have basic PBR setup, but cannot find good IPSLA configurations to pair with them.The 4948 has IPSLA, but does not seem to have the commands to tie it to t...
Hi,I would like to add servers to a site to site ipsec tunnel configuration for transport.However, I will need to NAT those machines for presentation at the other side. For a Cisco 1760 (vpn endpoint) running on 12.3 code, is this possible?If it is p...
I am trying to add a WIC1 DSU T1 which uses an RJ connector to this router.The card does not "power up" when the router is booted and is not seen by the IOS. I removed a WIC1 DSU 56k, and two WIC T1's from this router before attempting go install the...
I am not sure why this would be blocked since the router will not forward it anyway.
The broadcast will reach the router and the router will drop the traffic, but this ACL entry
only causes the router to drop it anyway.
Is there a reason that i...
Hi Ganesh,Thats a great article for WCCP, but I am replacing WCCP with PBR, and need to know the requirements for PBR on the 6500. If you have any direction at all for those requirements, I would be very grateful. Thank you again,Paul
Hi Ganesh,Actually I am trying to supplant WCCP on the 6509 as it seems to hang even when implemented in hardware.In the 6509 I don't see the IP SLA options with this code:(s3223_rp-IPBASE_WAN-M), Version 12.2(18)SXF17, RELEASE SOFTWARE (fc1)Do you k...
Hi Ganesh,It did take that command, and this is the output:: #sho track 99Track 99 IP SLA 99 reachability Reachability is Up 1 change, last change 00:00:16 Latest operation return code: OK Latest RTT (millisecs) 1 Will this tie it all together...
