Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,The command "ppp multilink endpoint ip" was introduced in 12.2, you can use the link below for your reference.http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fdial_r/drfmupp.htm#wp1094597HTH,Ansley
Hi,If you are using Dialer-Watch you can use the command below."dialer watch-disable seconds" - Apply a disable delay time to the interface. After the primary interface recovers, this delay prevents disconnecting the backup interface for the specifie...
Hi,Base on the output that you've shown S1/0:0 is up/down, you cannot bundle this two if one of the link is down, please make sure that L1 & L2 is up.If my assumption is not right and S1/0:0 is up/up and you really need to configure PPP multilink wit...
