mlppp multilink bundle cmds

[fprime7]

Hi

I am trying to setup an int Multilink1

======================================

interface Multilink1

description MLPPP

no ip address

no ip redirects

no ip mroute-cache

peer default ip address 172.29.194.18

no keepalive

ppp ipcp dns 172.25.72.1 172.25.76.1

ppp multilink

ppp multilink interleave

ppp multilink group 1

ppp multilink endpoint ip 172.29.194.17

I cannot add ^ endpoint while configuring the multilink interface 1

runnning IOS 12.2(3)

I can add the command to the int S1/1:0

Thanks for any assistance

Frank

[ansley.verzosa · Accepted solution]

Hi,

The command "ppp multilink endpoint ip" was introduced in 12.2, you can use the link below for your reference.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fdial_r/drfmupp.htm#wp1094597

HTH,

Ansley

[fprime7]

Thank you for your responce

I have a sample config that show the

"ppp multilink endpoint ip" in the multilink config

I have IOS 12.2(3) and that command is not able on MLP bundle

your link states

Do not configure the ppp multilink endpoint command on MLP bundle interfaces. Configure this command on each interface that will be an MLP bundle member, not on the bundle interface itself.

can you configure on the MLP bundle ?

which IOS on 7204 VXR ?