Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have a EEM script where I use the '$_cli_result' command to display it in the output. I'm not entirely sure if this would be saving to the flash and then the $_cli_result command is pulling from there. I don't think it would save to flash but I'...
I have a script where i'm running multiple commands and displaying it on the CLI session but am trying to just have the script without repeatedly pressing space which is why i have term len 0 at the start. However it doesn't seem to recognize the ter...
I'm trying to have EEM script where I run the script manually and it display the output of the results in the session but for some reason I'm unable to do so. This is what I have so far(config)#event manager applet TestCommand(config-applet)# event n...
im not sure why but when i do terminal monitor and then debug even manager action cli followed by running the eem scipt i get the results of my script however i don't see any debug output on the session
