Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a customer that wants to prioritize printing on tcp port 9100 and handheld scanners on tcp port 11590 in addition to the current prioritization of Avaya IP Office VoIP. Web browsing would be the lowest priority out of the three . I'm not qui...
I am wanting to deploy a 2504 with 8 AP's that can support three IP networks simultaneously, 10.130.0.0, 192.168.0.0 and 192.168.1.10 (Guest Network). I understand this is supported, but haven't really seen any examples of how to accomplish this. A...
Cadet,Everything goes across the multilink, no VLAN's on either side. What I need direction on are the commands for the ACL and then the corresponding class-map and policy map commands re. the ACL.Thanks
Jerryard1,Just a followup on what I was able to do. I have the 10.130.0.0 network on the management interface, port 1 with dynamic AP management enabled. I then created a dynamic interface for the 192.168.1.0 network and have that on port 3, with d...
If I understand, I need to create interfaces 2 & 3 to be dynamic, using physical port 1, then create a trunk on the switchport for all three VLAN's? My problem is that I do not have a Layer 3 device on the lan, just seperate physical switch stacks f...
OK, that makes sense. As my layer 2 infrastructure is on separate physical switch stacks, with no routing on the lan, can I connect each network into a separate physical interface on the 2504?
