Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I tried to write these commands in CLI (using Putty) for cisco ISR1100-4G but it seems like the VLAN command is not recognized.Regards,Aria Step 1Ensure that the router is in the factory fresh mode. If the router is not in the factory fresh mode,...
Hi.I try to open web interface for ISR 1100 cisco router but it is showing incomplete. I don't have the configuration rebon and all I have in navigation menu is Dashboard and Monitoring.I shared the screenshot. Regards,Aria
Hi. I tried different ISO image files and I used USB flash (2GB memory) to get out of ROMMON mode in my router ISR1100 4G.I type in ROMMON mode dir usb0: and then power off and power on the router, but I keep seeing this message: (Unsupported...
Hi. Thanks. It seems like the ISR1100-4G boot from controller managed mode and I cannot switch to autonomous mode. The reason I cannot see the full menu is this. What is your opinion?
Hi. There are the commands:Router#show run | in bootboot-start-markerboot-end-markerdiagnostic bootup level minimalRouter#show platformChassis type: ISR1100-4GSlot Type State Insert time (ago)--------- ------------------- --------------------- ------...
Hi. Here are the outputs of commands:Router#show versionCisco IOS XE Software, Version 17.12.03Cisco IOS Software [Dublin], isr1100be Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 17.12.3, RELEASE SOFTWARE (fc7)Technical Support: http://www.cis...
Hi. Thanks. I tried first configure the interface 0 and defined an IP for port 0 but when I connected to the Web interface then the menu showing was incomplete. As I only saw Monitoring and Dashboard menu and other menu were hidden. Do you have any ...
