Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,Recently I build a remote access vpn on ASA 5510. Users are able to login from outside. I created a DMZ wireless zone for wireless users and they are not able to login to the VPN using public IP Address. I excluded nat from the wireless rout...
I'm trying to get my CNR configure to work with Option 43 for 1240 series.So far I didn't have any luck.Can somebody help me.I just upgraded to 6.2IP address of management controller is 172.24.1.5vendor-option create "Cisco c1240"
Wait for the key to be changed and proceed with your loginPSMake sure that you have command listed below in your configaaa authentication enable console (your Server name) LOCAL
I ended up creating 2nd profile for Cisco VPN client.Now the issue is that client are able to connect to the inside of the network using vpn client but not to DMZ. (You can access dmz if you vpn from outside)Could it be the problem that you coming fr...
So only one solution will be to use multiple Cisco VPN profiles for the end users.Is there any way that I can setup some kind of redirecting ?So whenever Wireless client trying to connect to VPN using outside ip address it will do a translation to th...
Wireless users using outside IP address as VPN Server.If I enable IPSEC and the dmz interface they are able to connect.Issue is that all wireless users will required to have multiple VPN profiles (to connect to inside from wireless and outside)I was ...
