Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
NAT Exempt configuration for Sit to Site VPN traffic on our Cisco Firepower device managed via FDM.
Currently, FDM does not allow ASA-style NAT commands (such as nat (...)) in the CLI or through FlexConfig. These commands are blocked because FDM uses...
Cisco ASA to FTD on Firepower hardware FPR1010! eplacing the entire operating system from ASA to FTD. trying to install an FTD image from a USB drive on their FPR-1000 but can't see the USB when using the show flash: or dir /all
the imge i have on th...
Hello everyone.
Has anyone had this problem before? my secondary device is keeps failing And it's keep telling me (Event description: Interface check This host:1 single_vf: diagnostic Other host:0 ) That I looked at the management interface I ever se...
Hi
I have two cisco 1120 firepower running on (HA)
i configure the Management ip on both FDM but i cant access ftd gui and also i cant ping able to the ftd. I can access the FDM by Reaching the default gateway on my inside on https:// and i give ma...
Hi,
We are currently using 7.2.8-25 and want to upgrade to 7.4.2.1-30 (latest).
None of the bugs available would do any effect in environment and we are using the FDM.
Anyone have any opinion on either of the releases? One more buggy than the other? ...
Hi @judith75hodges I fixed the problem I don't know if you have the same problem but in my case it was the management interface IPv6 it was turned down that's why its keep failing as soon I turned up the IPv6 problem solved.
I hope this can be he...
