I want to configure netflow on VPN Concentrator, I have a 3030 VPN Concentrator but I dont how to configure it data flow export.Kindly help me out in this regard.Thanks
I am using VPNCON to provide Site to Site and remote access VPN's...I have 8Mb internet link 20 VPN's active.I want to allocate specific bandwidth to VPN users.e.g. User1 can only use 512K of 8Mb and User2 can use 2Mb of bandwidth.Can I restrict my V...
I am unable to identify differences between ISR, ASR and Multiservices platform router, specially between ISR and ASR routers.Kindly anyone here differentiate among these routers.Thanks
I am facing issue on Cisco 4506 and 4507 switches that I am running OSPF on both the switches and when I set interface bandwidth to 2048 then it is calculating its cost as 488 instead of 48, where as when I set interface bandwidth to 2048 on other sw...
Hi,were you able to fix the issue of not being able to reach end host from another edge device? I am running into the same problem. I will appreciate a response. I have routes on the BN and I can get to hosts in different VNs from BN, but Edge node d...
Thanks a lot....One more question arises from your explanation.When 7200VXR can be used for DATA, VOICE, VIDEO and therefore can be described as Integrated Services router, Then why we should go for ASR then??? because ASR is similar to 7200 and 7600...
Hi,I dont get why its taking first available IP as 10.160.0.1, what is the criteria of selcting IP, because it is not the lowest niether higher IP, it sits in the middle.IPs are 10.68.0.1, 10.160.0.1 and 10.255.25.1
Hi Kevin,Thanks for the information, after removing the auto-cost reference-bandwidth command now its working fine, thanks again.Could you please also reply for CDP issue. If source interface is not set then what is the criteria for selecting IP is t...