Hi,I would like to know procedure to utilise the command username in global configuration mode.If I set username and password at Router(config)# prompt, to which login it effectsRegards,Nanda
May be it helps.. I think you are doing NAT overload on interface Dialer1. In looking at the interface Dialer1 configuration, IP address is set to negotiate. The IP may be dynamically changing and breaking the NAT translation.
What happens when y...
For the above scenario what I think you are trying to do is to configure static NAT for two different IP host (x and y) to a single mapped IP (a.a.a.a) and you are getting below error.
ERROR: access-list used in static has different local addresses
F...