Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is this possible?in short topolgy is as follows:serverA -> Pix -> Chekpoint -> serverBNat is done on the Checkpoint. HoweverServerA -> ServerB produces 305005(no translation group)Between the PIX and the Checkpoint I have ohter devices that ServerA...
If I read you correctly, you want a hard ceiling at 200M period. Without a burst headdomm..rate-limit output 200000000 0 0 conform-action transmit exceed-action dropNot sure If I'd do that... but.
EtherChannels "bundle" ports. You'd do this to increase bandwidth. SO just like single ports Ethernet Channesl can also create loops, and can run STP as a "collective" i.e not for each port within the channel.
Based on the diagram, this should work.I would suggest that STP is favoring the RF links. What's not know is where the STP root is. I'd tear down / diaable the RF and carefully map out the STP costs, etc. Re-enable the RF, and again check out the S...
Not sure why you can;t configure IP on the second switch. Do you receive an error message of any sort.. duplilcate IP ?However...HSRP requires 3 address, 1 virtual and 2 physical. Pinging the virtual address (.1) will result in the echo coming from...
