Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Small issue I'm having when I run an adhoc command in NetConfig sending the command 'reload'. While the switch itself does infact restart, the NetConfig says that the job failed. It says failed as it times-out waiting for a response to the command (o...
I think the problem is that at one stage a complete device credential check was run which populated the table with the failed results. These results could be quite stale, and will remain until their state changes through another check. I think what w...
Sorry for dredging up an old post, but I'm having a few problems following this same procedure.Updating the IOS is no problem, but when I go to reload the switch at a later time using netconfig the job says 'failed' and returns the fail message : 'Me...
