Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have implemented a CISCO 2811 ISR in our network. I configured a DHCP on the router but it is not working. None of the clients are able to get a DHCP address from this 2811. Here is how I have configured the DHCP.ip dhcp smart-relayip dhc...
Hi,We have a 2811 router with VPN and NAT configured. We have two internet connection from different ISPs. The speed of our original connection is 2MB up and down. The speed of our new connection is 1MB up and down. We want to configure load balancin...
We replaced a PIX 501 at our headoffice with 2811, IOS- advanced Security, version 12.4(8). We cannot get our VPN working. Everything else is working as it should be. Here is our VPN config from 2811*****************************************crypto isa...
Hello all,We recently replaced a pix 501 with a cisco 2811 in our head office. We have created and applied access lists and everything is working fine now except our passive ftp. Some of our clients who try to access our as400 via ftp can connect but...
Hi Vikas,Please ignore the above debug document as after I copied that info, there were some more events generated. Attached is the full debug from pix.thnx,Palwinder
Hi Vikas,The ip inspect ARULE is just an inspect rule for passive ftp. I tried removing it but still no luck. Even I am new to SDM. Clicking on button 'configure your FW' does not do anything. This SDM thing is not so good. It just adds a lot more u...
Hi Vikas,Thanks for your reply. There is an option in SDM to check the VPN status. When I check it I get an error that there is a problem in my firewall. I have attached the SDM report with this mail. Can you please give me an example for NAT Bypass ...
