Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have implemented QoS (I wanted to give higher Priority to TCP based data/packets than UDP based data/packets on my four 2955 switches making Mesh topology and running RSTP Protocol)by using following commands successfully:conf t priority-list 1 pro...
I need exactly the CLI based commands to configure the following scenario: I have Four Catalyst 2955 Switches with Enhanced Image software and all four switches are connected in Mesh Topology and Running RSTP (Rapid Spanning Tree Protocol). While all...
Dear Friends,I need exactly the CLI based commands to configure the following scenario:I have Four Catalyst 2955 Switches with Enhanced Image software and all four switches are connected in Mesh Topology and Running RSTP (Rapid Spanning Tree Protocol...
Assalam-o-Alakium...I am in trouble with implementation of Access Control List (ACL). I have one Catalyst 2955 switch and I have Two computers with 192.168.200.60 (PC1) and 192.168.200.70 (PC2)while Switch IP address is 192.168.200.50.Actually when I...
I have 4 Catalyst 2955 switches as Mesh Topology and running RSTP protocol. I want to implement Traffic Prioritization...i.e. I want some packets/traffic from few special computers will get priority first from switches ...while other remainig compute...
thanks but I already read this document but I am the begnner in Cisco...I am confused that this document contains lots of commands so which commands I will need? can you send me approx. commands which I can run on switches as it is? The whole scenari...
Thanks and I tested it...it is working. This is Standard ACL, can you give (after testing) and Extended ACL based on MAC address and TCP/UDP protocol based?Last question is that I configured my Switch by given IP address on VLAN1 (which is by-default...
Yes my Switch is with EI software.One thing which I missed that I given IP address of Switch to VLAN1...so now pls. tell me how I can configure ACL for VLAN1 for restrciting PC to access other PC or will be able to stop some packets to go to another ...
THANKS.I have solved my problem by Bridging links on PC2 by installing XP...as you told earlier.Does Windoes 2003 Enterprise Server also give Bridging option as Win XP gives?Shahid
I did as you told by enabling Routing and Remote Access Service on PC1. with same and with diff. subnet...but it is not ping/access as I want.....???Any other solution???PLs. help me.Regards,Shahid
