Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi! I was wondering whether the pre-empt command should be used on both the devices which are on HSRP or should it be used only on the active device. Is at all it is to be used on both the devices please give me an example scenario.Thanks,AbhisheK
Hi,You might have a look at the following link ,it should help...http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a00800d84b9.htmlHope it helps...Regards,AbhisheKPlease rate helpful posts!!!
Hi Nitin,For load balancing the internet traffic, you can go for configuring policy based routing. Using policy based routing you can direct the packets to take different paths. This way you can also prioritise your traffic like giving preferential t...
Hi,First download a TFTP server program such as Solarwinds TFTP Server --> http://support.solarwinds.net/updates/New-customerFree.cfm?ProdId=52Then run it on the PC you want to act as TFTP server.Thereupon you give the IP of this PC as the IP for TFT...
Hi,protect - drops all the packets with unknown source addresses, after the limit of secure addresses on that port is reached.restrict - Sends an SNMP trap and also causes the switch to increment the security violation counter.For more on port securi...
Hi,What I understand is that you want only specified devices to be on your network, isnt it?Well, what you can do is define a mac address based access control list and then apply a vlan-map to block or pass the traffic from those mac addresses.Have a...
