Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody.I am **lly new with Cisco and I am currently struggling to set up my new switch (Day 0 setup).The switch does not generate an IP **bleep** for the connection to my laptop.Laptop is in client mode. Server resetted (hardware button) severa...
Hi Leo.Please see here my result for "sh romvar": MainSwitch1#sh romvar ^% Invalid input detected at '^' marker.Maybe the command is wrong (I am running version 16.03.09)? For the password-recovery I am not 100% sure.I ...
Hi CMack6I have exactly the same problem as you. Did you find the failure? My switch is booting into the correct firmware (16.03.09), but still not loading the startup-config automatically.If I copy the startup-config into the running-config all is w...
Hi Liviu.Again, thank you for the video.After setting up the configuration (as shown in the video), I was able to enter the webui. What a success!!!Unfortunately, after finishing the setup and disconecting the switch from the power supply, all settin...
Hi ammahend.I hope I could do it correct.Please find here the show run output:***********************************************************************May 22 19:23:08.474: %NGWC_USB_CONSOLE-6-USB_REMOVE: Switch 1:enableSwitch#show runBuilding configura...
