Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible that you can failover with the following scenario ?PIX 515E with 64 MB RAM,VAC is our primary production PIX.We bought a new failover firewall with 128MB RAM,VAC+ card.We just dont want to disturb the hardware configuration of the prod...
We bought a new PIX with 7.2(2),We are having issues configuring the IP address and telnet to the PIX from inside network.On the running configuration it shows ip address for the interface but the "show interface" shows "ip address unassigned".Please...
Thanks Jon.Is there any possiblity that we can disable the functionality of the VAC+ card on the Secondary PIX and to make failover with the VAC card on the Primary ? Luckily we bought the Memory upgrade pack for the Primary unit.
Guyz,Finally this issue has been fixed with the help of 'googling'.Issue the command "failover" in the global configuration to change the mode from Standby to Active.Now you will be able to assign IP address for the interface's and it will show the i...
Hi Mark,Thanks for your reply.Wouldn't be possible that you we can assign the ip address's for the interfaces with my existing PIX-515-SW-FO licence and test it ?You mean the existing licence will not give an option to configure the PIX remotely ?
Hi Fernando,It really helps,thanks a lot for this answer.If this is the case,we wont be able to configure this device except from the console session ?,also it can't be used as a stand alone PIX ?Or is there any possibility that we can get the licens...
I am pasting the show version command output herepixfirewall# sh ver Cisco PIX Security Appliance Software Version 7.2(2) Device Manager Version 5.2(2) C...
