Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello floks i have heard thst cisco does not support 7.1 ios on pix 520. i have a lab with pix520 with 16 megs flash 128 ram what i would like to know is if it can be upgraded to 7.1 ios, would like to practice with the new adsm any suggestions . tha...
hey floks i some how corrupted the flash on my 3640 and was wondering how i could erase that bad flash while in rommon mode, i have a new ios on another flash and can boot to it ,so when i do a dir flash: i only see the good ios but i can see the co...
hey folks could really use your input. i deleted my ios on my 2950 so that i could upgrade the ios to a newer one but in the middle of the upgrade i lost power, now i am tring to use xmodem to recover the ios but it gets to cccccccccc and i get $$$$$...
hello i was in the middle of upgrading flash on my 2950 and the power went out so i now have a switch without flash in switch: mode tryed to do an xmodem up download but it starts get a few CCCCC then get I/O error any help please.tried it several ti...
hello floks i have a 2950 with ios 12.1 (6) when i try to create a vlan i need cant do it from the config mode according to my cisco book that is how i create vlans and name them but i can only do it from the previlage mode not from the config t mode...
thanks i got the switch a few weeks ago and it worked fine with the old ios, but i wanted to upgrade it to the newest ios , it does respone to flash_init, load_helper, and other commands but , well i guess i will have to just take the books word for ...
hey thanks for your replies this is the command i am usingswitch: copy xmodem: flash:c2950-i6q4l2-mz.121-22.EA10.bin. It starts out ok but after 10 C's then i get 6 $ and an I/O error tried many times wondering if i am missing any steps. have looked ...
hello again looking at switch: dir i getflash[0]read/writexmodem[1] read onlynull [2] read/writebs[3] read/writetring to download new flash to 2950 but when it starts unisng xmodem it start with CCCCCCCCC then i get I/O error same place every time an...
hey thanks again floks for you input and helps.think iam getting the hang of it, just one more ? why cant i delete the flash from my 2950 keep getting no file such if name need i was able to upload it to my tftp server but need to delete it to downlo...
