Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Everyone ,
I am getting some latency over DMVPN tunnel from SPOKE router to reach to HUB router Tunnel interface Ip address .
Latency for public ip address of HUB router which is used to DMVPN is fine . Only getting latancy for tunnel Ip addre...
HI Ricardo ,
We have multiple spoke sites , Its seems to be issue with only one site .
Have already checked the memory and CPU utilization on HUB and SPOKE router its seems to be fine not going more then 5 % .
And we are not using any module for ...
The Model of HUB router and spoke is
Spoke : C2951 Software version : C2951 Software (C2951-UNIVERSALK9-M), Version 15.1(4)M8, RELEASE SOFTWARE (fc2
HUB : C3900 Software (C3900-UNIVERSALK9-M), Version 15.1(4)M8, RELEASE SOFTWARE (fc2)
I am measur...
Did you let us know the Debug output for snmp ,
Run this command .
"debug snmp event"
"debug snmp error"
"debug snmp packet"
You can see the snmp packet where its getting failed and why
You Can use packet tracert in ASA and check the logs on Router
packet-tracer input [src_int] protocol src_addr src_port dest_addr dest_port
Ex for ASA : packet-tracer input ( Interface name ) tcp 10.1.1.1 5067 10.4.1.1 23
