Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I'm experiencing a UI/UX issue with the Cisco Secure Firewall Management Center (FMC). Version: 10.0.0 (build 141) Model: FMC for VMwareWhen viewing or editing the Access Control List (ACL) rules, the modal window/container is extremely s...
Hello. Could you please tell me how to do this better?What is the best way to design Cisco ISE roles: keep Primary/Secondary PAN and MnT separated “crosswise” on different management nodes or combine Primary PAN and Primary MnT on a single node from ...
Hello. Please help me with the following question.We're planning to deploy ISE virtual machines. We have two data centers. The architecture is as follows:Data Center 1 - ISE node 1 (PAN + MnT + pxGrid primary)Data Center 1 - ISE node 3 (PSN)Data Cent...
Hello.Please help me understand the problem with Site to Site VPN.We have a cisco ASA on one side and a cisco ISR on the other. The ASA is behind NAT.When we initiate payload traffic to the ASA side, "show crypto ikev2 sa" shows nothing on either the...
Good afternoon. I've attached a screenshot. As you can see, there are 32 lines in the ACL, but only two are visible. This view is very inconvenient for viewing the entire ACL. I tried changing the screen resolution, but it didn't help. The open windo...
