Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI.
I want to ping 10.10.10.10 source 20.20.20.20 at 6500
ASA is natting source ip 20.20.20.20 -> 100.100.100.100
first of all, only think VRF1/BD1
how I should config static for 100.100.100.100
at external EPG N3K-1, static next-hop is 192.1...
Hi
when I make ASA service graph for EPG to External routed network in ACI,
it is not working... function connector is not generated
but, when I make ASA servcie graph for EPG to EPG, it is ok
I capture the screen shot and attach it
please giv...
HI, I am studying ASA dynamic VPN
R5 is headquarter, R6 and R7 are branch
I succeed in ping test between headquarter and branches
(between R5 and R6), (between R5 and R7)
but I failed to ping test from branch to branch
(between R6 and R7)
here is...
HI
thank you for answer, I will try to config your answer
but, I am not good at english and ACI....,
so I need to check if my interpretation is correct or not
1. configure a static route on 'ASA_OUT' for the natted address that points to a next ...
HI!!
I need your help, could you see my log?
I config the same like
I configurated http://www.cisco.com/c/en/us/support/docs/cloud-systems-management/application-policy-infrastructure-controller-apic/200407-L4-L7-Route-Peering-with-Transit-Fabric.h...
HI
I made it
I completed asa_out , really thank you!!
first of all, I just update whole config!!!
now, I am finally making service graph for EPG to external routed EPG
Iam not yet finishing making service graph, but I think it will be no problem...
excuse me
this is below fault of asa_out
if it is not you want, tell me what you need detail, I will capture and send you
(i am very beginner)
thank you
excuse me
you mean the fault of asa_out_EPG ??
I will capture tommorow and reply
thank yo...
